3Com 5500G-EI Command Reference Guide - Page 124
Access Management, Configuration, Commands, am enable, Syntax, Parameter, Description, Example
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 124 highlights
124 CHAPTER 5: USING NETWORK PROTOCOL COMMANDS The information displays in the following format: The DHCP server group of this interface is 0 The information shown above indicates that vlan-interface 2 is configured with a DHCP Server group whose ID is 0. Access Management Configuration Commands This section describes the commands you can use to configure and manage the Access Management Configuration operations on your Switch 5500G-EI. am enable Syntax am enable undo am enable View System View Parameter None Description Use the am enable command to enable the access management function. Use the undo am enable command to disable the function. By default, the Access management function is disabled. When using the access management function, It is recommended that you cancel the static ARP configuration to ensure that the binding of the IP address and Ethernet switch takes effect. If you have configured the static ARP for an IP address in the current port IP address pool from another port, the system will prompt you to cancel the static ARP setting. Example To enable the access management function, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]am enable am ip-pool Syntax am ip-pool address-list undo am ip-pool { all | address-list } View Ethernet Port View Parameters all Enter to configure to operate on all the IP addresses (or IP address pools).