Home » 3Com Manuals » Hubs & Switches » 3Com 5500G-EI » Manual Viewer

3Com 5500G-EI Command Reference Guide - Page 129

Parameter, Description, Example, udp-helper enable, Syntax, udp-helper port, VLAN interface ID.

UPC - 662705493534

Add to My Manuals
Save this manual to your list of manuals

Page 129 highlights

UDP Helper Configuration Commands 129 Parameter vlan_id VLAN interface ID. Description Use the display udp-helper server command to view the information of destination Helper server corresponding to the VLAN interface. Example To display the information of destination Helper server corresponding to the VLAN interface 1, enter the following: display udp-helper server interface vlan-interface 1 interface name server address packets sent VLAN-interface1 192.1.1.2 0 udp-helper enable Syntax udp-helper enable undo udp-helper enable View System View Parameter None Description Use the udp-helper enable command to enable relay of UDP broadcast packets . Use the undo udp-helper enable command to disable relay of UDP broadcast packets . By default, relay of UDP broadcast packets is disabled. Example To enable the UDP Helper function. system-view System View: return to User View with Ctrl+Z. [SW5500]udp-helper enable udp-helper port Syntax udp-helper port { port | dns | netbios-ds | netbios-ns | tacacs | tftp | time } undo udp-helper port { port | dns | netbios-ds | netbios-ns | tacacs | tftp | time } View System view

Section	Page
About This Guide	19
Using System Access Commands	23
Using Port Commands	47
Using VLAN Commands	79
Using Power over Ethernet (PoE) Commands	91
Using Network Protocol Commands	101
Using Routing Protocol Commands	143
Using Multicast Protocol Commands	235
Using QoS/ACL Commands	281
Using RSTP Commands	317
Using Fabric Commands	337
Using AAA and RADIUS Commands	341
Using System Management Commands	397