3Com 5500G-EI Command Reference Guide - Page 35
Example, protocol inbound, Syntax, Parameter, Description, By default
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Logging in Commands 35 Example To set mark parity on the AUX (Console) port, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]user-interface aux 0 [SW5500-ui-aux0]parity mark protocol inbound Syntax protocol inbound { all| ssh | telnet } View VTY user interface view Parameter all: Supports both Telnet and SSH protocols. ssh: Supports only SSH protocol. telnet: Supports only Telnet protocol. Description Use the protocol inbound command to configure the protocols supported by a designated user interface. By default, the user interface supports Telnet and SSH protocol. For the related commands, see user-interface vty. Example Configure SSH protocol supported by VTY0 user interface. system-view System View: return to User View with Ctrl+Z. [SW5500]user-interface vty 0 [SW5500-ui-vty0]protocol inbound ssh quit Syntax quit View All views Parameter None Description Use the quit command to exit from the current view to the next highest view. If the current view is user view, this command quits the system. There are three levels of view, which are, from high to low: ■ user view