3Com 5500G-EI Command Reference Guide - Page 382

382 CHAPTER 11: USING AAA AND RADIUS COMMANDS Parameter ip-address: IP address, in dotted decimal format. port-number: Specifies UDP port number. ranging from 1 to 65535. . Description Use the primary accounting command to configure the IP address and port number for the primary accounting server. Use the undo primary accounting command to restore the default IP address and port number of the primary RADIUS accounting server. By default, as for the newly created RADIUS scheme, the IP address of the primary accounting server is 0.0.0.0, and the UDP port number of this server is 1813; as for the "default system" RADIUS scheme created by the system, the IP address of the primary accounting server is 127.0.0.1, and the UDP port number is 1646. After creating a RADIUS scheme, you are supposed to set IP addresses and UDP port numbers for the RADIUS servers, including primary/second authentication/authorization servers and accounting servers. In real networking environments, the above parameters shall be set according to the specific requirements. However, you must set at least one authentication/authorization server and an accounting server. Besides, ensure that the RADIUS service port settings on the Switch is consistent with the port settings on the RADIUS server. Related commands: key, radius scheme, state. Example To set the IP address of the primary accounting server of RADIUS scheme, "3Com", to 10.110.1.2 and the UDP port 1813 to provide RADIUS accounting service, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]radius scheme 3Com [SW5500-radius-3Com]primary accounting 10.110.1.2 1813 primary authentication Syntax primary authentication ip-address [ port-number ] undo primary authentication View RADIUS Server Group View Parameter ip-address: IP address, in dotted decimal format. By default, the IP addresses of the primary authentication/authorization is at 0.0.0.0. port-number: Specifies UDP port number. ranging from 1 to 65535. By default, the UDP port for authentication/authorization service is 1812 .