3Com 5500G-EI Command Reference Guide - Page 167
Example, Syntax, Parameter, Description, preference
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 167 highlights
RIP Configuration Commands 167 When the network command is used on an IP address, the interface on this network segment is enabled. For example, if you view the network 129.102.1.1 with both the display current-configuration command and the display rip, the IP address is shown as 129.102.0.0. Related commands: rip work. Example To enable RIP on the interface with the network address 129.102.0.1, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]rip [SW5500-rip]network 129.102.0.0 peer Syntax peer ip_address undo peer ip_address View RIP view Parameter ip_address Enter the interface IP address of the peer router. Description Use the peer command to configure the destination address of the peer device. Use the undo peer command to cancel the set destination address. By default, there is no destination address. 3Com recommends that you do not use this command. RIP can use unicast to exchange information with non-broadcasting networks. If required, you can use this command to specify the destination address of the peer device. Example To specify the sending destination address as 202.38.165.1, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]rip [SW5500-rip]peer 202.38.165.1 preference Syntax preference value undo preference View RIP view