3Com 5500G-EI Command Reference Guide - Page 223
Example, filter-policy export, Syntax, Parameter, Description, Routing Protocol view
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 223 highlights
IP Routing Policy Configuration Commands 223 Example Display the information of Route-policy named as policy1. display route-policy policy1 Route-policy : policy1 Permit 10 : if-match (prefixlist) p1 apply cost 100 matched : 0 denied : 0 Table 40 Output Description of the display route-policy Command Field Route-policy Permit 10 Description Name of ip-prefix Information of the route-policy with mode as permit and node as 10: ■ if-match (prefixlist) p1 - The configured if-match clause ■ apply cost 100 - Apply routing cost 100 to the routes matching the conditions defined by if-match clause ■ matched - Number of routes matchng the conditions set by if-match clause ■ denied - Number of routes not matching the conditions set by if-match clause filter-policy export Syntax filter-policy { acl_number | ip-prefix ip_prefix_name } export [ protocol ] undo filter-policy { acl_number | ip-prefix ip_prefix_name } export [ protocol ] View Routing Protocol view Parameter acl_number Enter the number of the access control list used for matching the destination address field of the routing information. ip_prefix_name Enter the address prefix list used for matching the routing information destination address field. protocol Enter the routing information of which kind of route protocol to be filtered. Description Use the filter-policy export command to configure to set the filtering conditions of the routing information advertised by a certain type of routing protocols. Use the undo filter-policy export command to cancel the filtering conditions set. By default, the advertised routing information is not filtered.