3Com 5500G-EI Command Reference Guide - Page 501
NTP Configuration, Commands, debugging ntp-service, Syntax, Parameter, Description, Example
![]() |
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 501 highlights
NTP Configuration Commands 501 NTP Configuration Commands This section describes the Network Time Protocol (NTP) configuration commands available on your Switch 5500G-EI. debugging ntp-service Syntax debugging ntp-service { access | adjustment | authentication | event | filter | packet | parameter | refclock | selection | synchronization | validity | all } undo debugging ntp-service { access | adjustment | authentication | event | filter | packet | parameter | refclock | selection | synchronization | validity | all } View User view. Parameter access: NTP access control debugging. adjustment: NTP clock adjustment debugging. all: All NTP debugging functions. authentication: NTP authentication debugging. event: NTP event debugging. filter: NTP filter information debugging. packet: NTP packet debugging. parameter: NTP clock parameter debugging. refclock: NTP reference clock debugging. selection: NTP clock selection information debugging. synchronization: NTP clock synchronization information debugging. validity: NTP remote host validity debugging Description Use the debugging ntp-service command to debug different NTP services. Use the undo debugging ntp-service command to disable corresponding debugging function. By default, no debugging function is enabled. Example Enable NTP access control debugging. debugging ntp-service access
![](/manual_guide/products/3com-5500gei-command-reference-guide-41e7884/501.png)