3Com 5500G-EI Command Reference Guide - Page 116

116 CHAPTER 5: USING NETWORK PROTOCOL COMMANDS Example To configure VLAN interface 1 to obtain IP address using BOOTP, enter the following: system-view System View: return to User View with Ctrl+Z. [SW5500]interface vlan-interface 1 [SW5500-Vlan-interface1]ip address bootp-alloc DHCP Client Configuration Commands This section describes the commands you can use to configure and manage the Dynamic Host Configuration Protocol (DHCP) Client operations on your Switch 5500G-EI. debugging dhcp client Syntax debugging dhcp client { all | error | event | packet } undo debugging dhcp client { all | error | event | packet } View User view Parameters all Enter to enable all DHCP client debugging. error Enter to enable DHCP client error (including packet unrecognizable ) debugging. event Enter to enable DHCP client event (including address allocation and data update) debugging. packet Enter to enable DHCP client packet debugging. Description Use the debugging dhcp client command to enable DHCP client debugging. Use the undo debugging dhcp client command to disable DHCP client debugging. By default, all DHCP client debugging is disabled. Example To enable DHCP client event debugging, enter the following: debugging dhcp client event debugging dhcp xrn xha Syntax debugging dhcp xrn xha undo debugging dhcp xrn xha View User view