3Com 5500G-EI Command Reference Guide - Page 279
static-rp, Syntax, Parameter, Description, Example, command to con static RP.
UPC - 662705493534
View all 3Com 5500G-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 279 highlights
PIM Configuration Commands 279 System View: return to User View with Ctrl+Z [SW5500]multicast routing-enable [SW5500]pim [SW5500-pim]source-policy 1 [SW5500-pim]quit [SW5500]acl number 1 [SW5500-acl-basic-1]rule permit source 10.10.1.2 0 [SW5500-acl-basic-1]rule deny source 10.10.1.1 0 static-rp Syntax static-rp rp-address [ acl-number ] undo static-rp View PIM View Parameter rp-address: Static RP address, a legal unicast IP address. acl-number: Basic ACL, used to control the range of the multicast group served by the static RP, which ranges from 2000 to 2999. If an ACL is not specified at configuration, static RP will serve all multicast groups; if an ACL is specified, static RP will only serve the multicast group passing the ACL. Description Use the static-rp command to configure static RP. Use the undo static-rp command to remove the configuration. The Static RP functions as the backup for a dynamic RP so as to improve the network robustness. If the RP is elected by the BSR mechanism, static RP will not work. All routers in the PIM domain should be configured with this command and be specified with the same RP address. The new configuration overwrites the old one if you run the command for a second time. Related command: display pim rp-info Example Configure 10.110.0.6 as a static RP. system-view System View: return to User View with Ctrl+Z [SW5500]multicast routing-enable [SW5500]pim [SW5500-pim]static-rp 10.110.0.6