Asus S82A S86A S82/S86 User Manual (English version) - Page 68

5. Configuring the BIOS Sectors: This field configures the number of sectors per track. Refer to your drive documentation to determine the correct value to enter into this field. NOTE: To make changes to this field, the Type field must be set to User. Maximum Capacity: This field shows the drive's maximum capacity calculated automatically by the BIOS from the drive information you entered. Multi-Sector Transfers: This option automatically sets the number of sectors per block to the highest number supported by the drive. This field can also be configured manually. Note that when this field is automatically configured, the set value may not always be the fastest value for the drive. Refer to the documentation that came with your hard drive to determine the optimal value and set it manually. NOTE: To make changes to this field, the Type field must be set to User. The configuration options are: [Disabled] [2 Sectors] [4 Sectors] [8 Sectors] [16 Sectors] LBA Mode Control: When Logical Block Addressing is enabled, 28-bit addressing of the hard drive is used without regard for cylinders, heads, or sectors. Note that Logical Block Access may decrease the access speed of the hard disk. However, LBA Mode is necessary for drives with greater than 504MB in storage capacity. NOTE: To make changes to this field, the Type field must be set to User. The configuration options are: [Disabled] [Enabled] 32 Bit I/O: [Enabled] When enabled, this option speeds up communication between the CPU and the IDE controller. This option supports PCI local bus only. ISA bus is not supported. NOTE: To make changes to this field, the Type field must be set to User. The configuration options are: [Disabled] [Enabled] Transfer Mode: When enabled, this option speeds up communication between the system and the IDE controller by using enhanced I/O transfer modes (PIO Modes). NOTE: To make changes to this field, the Type field must be set to User. The configuration options are: [Standard] [Fast PIO 1] [Fast PIO 2] [Fast PIO 3] [Fast PIO 4] Ultra DMA Mode: This field auto detects Ultra DMA capability (for improved transfer speeds and data integrity) for compatible IDE devices. Set to Disable to suppress Ultra DMA capability. NOTE: To make changes to this field, the Type field must be set to User. The configuration options are: [Disabled] [Mode 0] [Mode 1] [Mode 2] NOTE: After using the legend keys to make your selections on this sub-menu, press the [Esc] key to exit back to the Main menu. When the Main menu appears, you will notice that the drive size appears in the field for the hard disk drive that you just configured. 68