Behringer DEEPMIND 12D Manual - Page 107
NoiseGate NOISE GATE, Delay STEREO DELAY
View all Behringer DEEPMIND 12D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
107 DeepMind 12D User Manual NoiseGate (NOISE GATE) No DM12 REF PARAMETER UNITS MIN MAX DESCRIPTION 1* THR Threshold dB -50.0 0.0 Sets signal level at which gate opens. 2* RNG Range dB -100.0 0.0 Control adjusts the amount of gain reduction applied to the signal below threshold. 3* ATT Attack ms 0.0 20.0 Adjusts time taken for gate to open after an over-threshold signal. 4* REL Release ms 2.0 1999.9 Adjusts time taken for gate to close after programme material falls back below threshold. 5* HLD Hold ms 2.0 1999.9 This defines a waiting period before the gate starts to close. 6* PUN Punch - -6.0 6.0 Used to increase tonal shaping or reduce gated breathing/delay/resonant howl-round. 7 MOD Mode -- - GAT (Gate), TRN (Transient Gate), DUC (Ducker). 8 PWR Power - ON OFF Enables gate in the signal path. When switched off, gate is bypassed. * These parameters are available as modulation destinations in the Modulation Matrix Delay (STEREO DELAY) No DM12 REF PARAMETER UNITS MIN MAX DESCRIPTION 1* MIX Mix % 0.0% 100% Controls the mix (or ratio) of wet (processed) and dry (unprocessed) signals. 2 TIM Time ms 1.0 ms 1500.0 ms Adjusts the master delay time. Time synchronised options from 4 to 1/64 bars. 3 MOD Mode -- - ST- Stereo feedback, X - crosses feedback between channels, M - Mono mix in feedback chain. P-P - Ping Pong (Note that Feedback-R (FBR) is disabled in this mode. 4 FCL FactorL -- - Sets left delay to rhythmic fractions of the master delay (1/4, 3/8, 1/2, 2/3, 1, 4/3, 3/2, 2, 3). 5 FCR FactorR -- - Sets right delay to rhythmic fractions of the master delay (1/4, 3/8, 1/2, 2/3, 1, 4/3, 3/2, 2, 3). 6 OFS Offset ms -100.0 ms 100.0 ms Adds a delay difference between the left and right delayed signals. 7* LC LC Hz 10.0 Hz 500.0 Hz Adjusts the low frequency cut, allowing lower frequencies to remain unaffected by the delay. 8* HC HC Hz 200.0 Hz 20000.0 Hz Adjusts the high frequency cut, allowing higher frequencies to remain unaffected by the delay. 9* FLC FeedLC Hz 10.0 Hz 500.0 Hz Adjusts the low cut filter frequency in the feedback paths. 10* FBL FeedL % 0.0% 100% Control the amount of feedback for the left channel. 11* FBR FeedR % 0.0% 100% Control the amount of feedback for the right channel. 12* FHC FeedHC Hz 200.0 Hz 20000.0 Hz Adjusts the high cut filter frequency in the feedback paths. * These parameters are available as modulation destinations in the Modulation Matrix