Belkin F1PI210ENau User Guide - Page 16

section Advanced Setup Method Parameter Description Encapsulation Shows the packet encapsulation type. Packet encapsulation specifies how to handle multiple protocols at the ATM transport layer. • VC-MUX: Point-to-Point Protocol over ATM Virtual Circuit Multiplexer (null encapsulation) allows only one protocol running per virtual circuit with less overhead • LLC: Point-to-Point Protocol over ATM Logical Link Control allows multiple protocols running over one virtual circuit (using slightly more overhead) QoS Class ATM QoS classes including CBR, UBR and VBR. PCR/SCR/MBS QoS Parameters - PCR (Peak Cell Rate), SCR (Sustainable Cell Rate) and MBS (Maximum Burst Size) are configurable. Connect Type Sets connection mode to always connected, automatic or manual connection. Idle Time: Enter the maximum idle time for the Internet connection. (in minutes) After this time has been exceeded the connection will be terminated. Username: Enter user name Password: Enter password Confirm password: Confirm Password MTU Leave the Maximum Transmission Unit (MTU) at the default value (1500) unless you have a particular reason to change it. Advanced Setup Method 1 Clone MAC Address Clicking on the Clone MAC Address brings up the following screen. 2 3 4 5 6 7 Some ISPs may require that you register your MAC address with them. If this is the case, the MAC address of the VoIP Router must be changed manually to the MAC address that you have registered with your ISP. 28 29