Belkin F1PI210ENau User Guide - Page 37

Advanced Setup Method (Default: 50 ~ 250 milliseconds) Telephony Tone Country Setting: Select the country Voice Codec Configuration: Set the voice codecs Available Codecs: List of available codecs Selected Codecs: List of selected codecs, move the preferred codec to the top of the list with up and down buttons to the right. The codec at the top of the list will be used when it can Port Advanced Setting Configure advanced VoIP settings on this page then click "SAVE SETTINGS". Advanced Setup Method 1 Caller ID Mode Use DTMF Caller ID Mode. Enabling this option enabled the Dual Tone, Multi-Frequency (touch tone) mode for Caller ID. 2 Inter Digit Delay This is the delay time before processing the dialed digits. This will 3 delay the VoIP unit dial the telephone number after the digits have been entered. 4 T.38 Mode T.38 is the standard for sending faxes over IP networks. Enable this 5 option for Faxing over IP. Dial Tone(Hz) 6 Adjust the pitch of the VoIP dial tone. 7 Dialing Plans Configure the VoIP dialing plans on this page, and click "SAVE SETTINGS." section Volume Gain Control Use this option to adjust the volume of calls made through VoIP. VAD Voice Activation Detection. VAD is designed to conserve bandwidth by halting transmission of voice packets until it has detected a noise either by voice or outside noise. The downside to this is it may miss some packets due to a slight delay in the transmission of packets. Disable this if you are experiencing issues with phone system menus, faxing over IP etc. 70 Set the Phone Number and Connection Type on this page. 71