Bernina 830LE Manual - Page 42

Setup Program Update 42 Version ► the current versions of the sewing computer and the embroidery module (must be connected to the sewing computer) can be seen ► the total number of stitches and the number of stitches sewn since the last servicing by the BERNINA dealer are displayed Service Data Service data of the actual condition of your sewing computer can be saved on a USB stick and sent to your authorized BERNINA dealer: ► insert the USB stick into your sewing-/ embroidery computer ► touch «LOG» ► after the data is saved remove the USB stick Updating ► insert BERNINA USB stick with the new software version ► touch «Update» ► touch «Update» again to start the process ► it is then determined if: ‣ a BERNINA USB stick is inserted ‣ there is enough free space available (at least 10 MB) ‣ the correct software version is on the stick ► the data and settings are accepted ► if the update was successful, a message appears and the sewing computer is ready to sew again ► if the update cannot be started or if there are problems during the update process, an error message appears Do not remove the BERNINA USB stick until there is a message which indicates the end of the update.