Bosch NBN-498-11P Operation Manual - Page 105
Encryption, RCP+ port 1756, Telnet support, Interface mode ETH, Network MSS Byte, iSCSI MSS Byte
![]() |
View all Bosch NBN-498-11P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
Dinion2X IP Camera Advanced Mode | en 105 To limit connections to SSL encryption, set the Off option in the HTTP browser port, the RCP+ port, and Telnet support. This deactivates all unencrypted connections allowing connections on the HTTPS port only. Configure and activate encryption for media data (video, audio, metadata) on the Encryption page. RCP+ port 1756 Activating RCP+ port 1756 allows unencrypted connections on this port. To allow only encrypted connections, set the Off option to deactivate the port. Telnet support Activating Telenet support allows unencrypted connections on this port. To allow only encrypted connections, set the Off option to deactivate telnet support, making telnet connections impossible. Interface mode ETH If necessary, select the Ethernet link type for interface ETH. Depending on the device connected, it may be necessary to select a special operation type. Network MSS (Byte) Set the maximum segment size for the IP packet's user data here. This gives the option to adjust the size of the data packets to the network environment and to optimize data transmission. Please comply with the MTU value of 1,514 bytes in UDP mode. iSCSI MSS (Byte) Specify a higher MSS value for a connection to the iSCSI system than for the other data traffic via the network. The potential value depends on the network structure. A higher value is only useful if the iSCSI system is located in the same subnet as the camera. Bosch Security Systems Installation and Operation Manual AR18-10-B006 | v1.1 | 2010.06
![](/manual_guide/products/bosch-nbn49811p-operation-manual-26e459b/105.png)