Bosch NBN-498-11P Operation Manual - Page 50
Date/Time
View all Bosch NBN-498-11P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
50 en | Basic Mode Dinion2X IP Camera Confirm password Re-enter the new password to ensure that there are no typing mistakes. The new password is only saved after clicking Set. Therefore, click Set immediately after entering and confirming the password, even if assigning a password at another level. 8.3 Date/Time Device date, time and zone If there are multiple devices operating in the system or network, it is important to synchronize their internal clocks. For example, it is only possible to identify and correctly evaluate simultaneous recordings when all devices are operating on the same time. As the device time is controlled by the internal clock, it is not necessary to enter the day or date of the week. These are set automatically. The time zone in which the system is located is also set automatically. 1. Click Sync to PC to apply the system time from your computer to the device. Time server IP address The camera can receive the time signal from a time server using various time server protocols and then use it to set the internal clock. The device polls the time signal automatically once every minute. Enter the IP address of a time server. Time server type Select the protocol that is supported by the selected time server. It is recommended to select the SNTP server protocol. This protocol provides high accuracy and is required for special applications and future function extensions. Select Time server if the server uses the RFC 868 protocol. Note: It is important to ensure that the date/time is correct for recording. An incorrect date/time setting could prevent correct recording. AR18-10-B006 | v1.1 | 2010.06 Installation and Operation Manual Bosch Security Systems