Bosch NBN-498-11P Operation Manual - Page 125
Repairs
![]() |
View all Bosch NBN-498-11P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Dinion2X IP Camera Maintenance | en 125 Note: You must reboot to activate the new IP address, a new subnet mask or a gateway IP address. Reboot Briefly interrupt the power supply to the camera for a reboot (disconnect the power supply unit from the mains supply and switch on again after a few seconds). Additional Parameters You can use the terminal program to check other basic parameters and modify them where necessary. Use the onscreen commands in the various submenus to do this. 12.3 Repairs CAUTION! Never open the casing of the unit. The unit does not contain any user serviceable parts. Ensure that all maintenance or repair work is performed only by qualified personnel (electrical engineering or network technology specialists). In case of doubt, contact your dealer's technical service center. 12.3.1 Transfer and disposal The camera should only be passed on together with this installation guide. The unit contains environmentally hazardous materials that must be disposed of according to law. Defective or superfluous devices and parts should be disposed of professionally or taken to your local collection point for hazardous materials. Bosch Security Systems Installation and Operation Manual AR18-10-B006 | v1.1 | 2010.06
![](/manual_guide/products/bosch-nbn49811p-operation-manual-26e459b/125.png)