Bosch NBN-498-11P Operation Manual - Page 96
VCA configuration - Event triggered
![]() |
View all Bosch NBN-498-11P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
96 en | Advanced Mode Dinion2X IP Camera 9.8.5 VCA configuration - Event triggered This configuration allows you to stipulate that the video content analysis is only to be activated when triggered by an event. As long as no trigger is activated, the Silent MOTION+ configuration in which metadata is created is active; this metadata facilitates searches of recordings, but does not trigger an alarm. Trigger Select a physical alarm or a virtual alarm as a trigger. A virtual alarm is created using software, with RCP+ commands or alarm scripts, for example. Trigger active Select the VCA configuration here that is to be enabled via an active trigger. A green check mark to the right of the list field indicates that the trigger is active. Trigger inactive Select the VCA configuration here that is to be activated if the trigger is not active. A green check mark to the right of the list field indicates that the trigger is inactive. Delay (s) Select the delay period for the reaction of the video content analysis to trigger signals. The alarm is only triggered after a set time interval in seconds has elapsed and then only if the triggering condition still exists. If the original condition has been restored before this time interval elapses, the alarm is not triggered. A delay period may be useful in avoiding false alarms or frequent triggering. During the delay period, the Silent MOTION+ configuration is always enabled. AR18-10-B006 | v1.1 | 2010.06 Installation and Operation Manual Bosch Security Systems
![](/manual_guide/products/bosch-nbn49811p-operation-manual-26e459b/96.png)