Bosch NBN-498-11P Operation Manual - Page 28
Power connector - 28
View all Bosch NBN-498-11P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
28 en | Installation 5.2 Power connector AUDIO IN ALARM 1 2 3 4 5 6 VIDEO AUDIO OUT - + E 12 VDC T 24 VAC H P o E DATA 1 2 3 4 5 6 Dinion2X IP Camera 5 mm 0.2 in Figure 5.2 Power connection Connect power from a 24 VAC or 12 VDC class 2 power supply as follows: - Use AWG16 to 22 stranded wire or AWG16 to 26 solid wire; cut back 5 mm (0.2 in) of insulation. - Loosen the screws of the supplied 2-pole connector and insert the wires. - Tighten the screws and insert the 2-pole connector into the power socket of the camera. Note: For a DC supply the polarity is important. Incorrect polarity does not damage the camera but it will not switch on. AR18-10-B006 | v1.1 | 2010.06 Installation and Operation Manual Bosch Security Systems
28
en | Installation
Dinion2X IP Camera
AR18-10-B006 | v1.1 | 2010.06
Installation and Operation Manual
Bosch Security Systems
5.2
Power connector
Figure 5.2
Power connection
Connect power from a 24 VAC or 12 VDC class 2 power supply
as follows:
–
Use AWG16 to 22 stranded wire or AWG16 to 26 solid
wire; cut back 5 mm (0.2 in) of insulation.
–
Loosen the screws of the supplied 2-pole connector and
insert the wires.
–
Tighten the screws and insert the 2-pole connector into
the power socket of the camera.
Note:
For a
DC supply
the polarity is important. Incorrect polarity
does not damage the camera but it will not switch on.
1
2
3
4
5
6
E
T
H
P
o
E
ALARM
AUDIO IN
AUDIO OUT
VIDEO
DATA
1
2
3
4
5
6
–
+
12 VDC
24 VAC
5 mm
0.2 in