Bosch NBN-498-11P Operation Manual - Page 41
Network submenu, Defaults submenu
![]() |
View all Bosch NBN-498-11P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Dinion2X IP Camera Camera set-up | en 41 6.2.3 Network submenu To operate the camera in your network, a network-valid IP address must be assigned. The factory default IP address is 192.168.0.1 Function Selection Description IP Address Enter an IP address for the camera. Use LEFT/RIGHT to change position in the address, use UP/DOWN to select the digit. Use SELECT to exit the address edit screen. Subnet Mask Enter the Subnet mask (default 255.255.255.0). Gateway Enter a Gateway address. DHCP If the network has a DHCP server for dynamic IP address allocation, set this parameter to On to activate the automatic acceptance of DHCP-assigned IP addresses. Exit Return to the Install menu. The new IP address, subnet mask, and gateway address are set when leaving the menu. The camera reboots internally and the new values are set after a few seconds. 6.2.4 Item Defaults submenu Selection Description Restore All? No, Yes Restores all settings of the six modes to their default (factory) values. Select YES then press the Menu/Select button to restore all values. When completed the message RESTORED! is shown. Bosch Security Systems Installation and Operation Manual AR18-10-B006 | v1.1 | 2010.06
![](/manual_guide/products/bosch-nbn49811p-operation-manual-26e459b/41.png)