Bosch WTVC5530UC User Guide - Page 10
leading edge
View all Bosch WTVC5530UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
5. Rotate the door so that it is perpendicular to the dryer front. Slide the door away from the dryer so the hinge pins slide out of the grooves in the dryer door. 13. Note the new position of the cover glass. The leading edge of the raised glass edge should have moved 90 degrees clockwise from its starting point as shown in the illustration below as (A). 9. Remove the four screws holding the front ring to the door body. check to make sure that all four plastic bushings remain on the hinge pins 10. Flip the door over so the front ring faces up. 11. Remove the front ring from the dryer door. 14. Rotate the front ring 180 degrees so the door handle is now on the right hand side. The door handle is located on the inside of the front ring. It is a hand-sized indent. Avoid allowing the 4 plastic bushings to fall off the hinge pins. If any of the bushings do fall off, reinstall them on the hinge pins prior to reinstalling the door. 6. Lay the dryer door face down on a firm, flat, padded surface, with the bottom of the door facing towards you. 7. Remove the two screws holding the striker cover plate in place. Hold the striker while lifting the cover so as to keep the parts together in place and set the assembly aside for later reinstallation. striker 8. Remove the single screw that was hidden by the striker plate cover. 10 12. The cover glass has a raised glass edge that goes about two-thirds of the way around the glass. Be sure this raised edge faces up towards you. Observe the position of the leading edge of the raised glass handle, marked in the illustration below as (A). Rotate the cover glass 90 degrees clockwise. 15. Flip the door over so the back faces up. 16. Reassemble the parts, preserving their new alignments. 17. Reinsert the single screw that goes under the striker plate. TIghten the screw securely. 18. Rotate the striker cover and striker 180 degrees so the assembly fits to the install area on the opposite side of the door (where the hinge had been). Reinstall the striker cover and striker to the new location and securely tighten the two cover screws.