Bosch WTVC5530UC User Guide - Page 27

10. Rotate the program selector to Off". The dryer light goes out. 11. Clean the filter. The filter should be cleaned after each drying process. Cleaning the filter reduces the drying time and saves energy. 12. Close the door. Cleaning the lint filter A dirty filter extends the drying time and increases energy consumption. The filter should be cleaned before each laundry load. If a warning signal and a CLn" or E:12" warning message are emitted during a drying program, clean the filter immediately and check the exhaust duct. i The program interrupts automatically. Do not rinse or wash the screen to remove lint. Wet lint is harder to remove. Roll the dry lint off with your fingers. You can moisten your fingers lightly for better results. To clean the lint filter follow these steps: 1. Switch off the dryer by turning the program selector to Off". d CAUTION The inside of the door heats up during the drying process. Avoid touching any heated surface until it has time to cool. 2. Open the door. 3. Remove the lint filter. 4. Remove lint by stroking your hand over the filter. 5. Insert the filter. 6. Close the door. i Do not operate the dryer without the lint filter in place! Removing Residue Buildup Laundry detergent and fabric softener can build up on the lint filter screen. This buildup can cause longer drying times. Use of dryer sheets is not recommended. If you choose to use dryer sheets, please clean the lint filter periodically to remove residue. i If lint falls off the screen while it is in the dryer, residue buildup probably needs to be removed. The filter should be lightly scrubbed at least twice a year with warm soapy water. A filter with residue buildup will tend to hold water even though the mesh is lint free. The filter is clean when it no longer holds water. The filter must be dried thoroughly before being inserted back into the dryer. To remove residue, follow these steps: 1. Clean all lint from the lint filter. 2. Wet both sides of the filter mesh with hot water. 3. Wet a soft nylon brush with hot water and liquid detergent. 4. Lightly scrub the lint screen with the brush to remove residue buildup. Be careful not to damage the screen. 5. Rinse the screen with hot water. 6. Thoroughly dry the lint screen with a clean towel. 7. Replace the lint filter back into the dryer. i Do not operate the dryer without the lint filter in place! 27