Bosch WTVC5530UC User Guide - Page 29
Cleaning, and care
View all Bosch WTVC5530UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Cleaning and care Cleaning the dryer d WARNING TO AVOID RISK OF EXPLOSION! Never use solvents or highly flammable liquids for cleaning. NOTICE Incorrect cleaning may damage the dryer. Do not spray with a pressure washer. Do not use scouring agents or allĆpurpose cleaners. Do not use steam cleaners. Wipe the housing and the control panel with a soft cloth and soapy water only. Wipe the drum, door seal and inside of the door with a damp cloth only. Cleaning the exhaust duct Inspect and clean the exhaust ducting at least once a year to prevent clogging. A partially clogged exhaust will lengthen the drying time and will result in poor performance of the dryer. q Turn off the circuit breaker q Unplug the dryer from the power supply. q Disconnect the duct from the dryer. q Vacuum the inside of the duct to remove any accumulation of lint or debris . q Reconnect the duct. q Professional duct cleaning is recommended. See page 17. Cleaning the moisture sensor The moisture sensor has to be cleaned periodically because a fine layer of transparent buildup is deposited on the sensors. This deposit can easily be removed by wiping the sensors (the two bars next to the lint filter) with a cloth and a little white vinegar. Use white vinegar only! Clean the moisture sensor once a month. Cleaning the lint filter housing Lint and small debris may accumulate in the lower portion of the lint filter opening. With the lint filter removed, accumulated lint can be seen and easily removed with a vaccum cleaner using a narrow crevice cleaning tool. If you do not have a crevice cleaning tool that will reach to the bottom of the opening, you may contact Customer Service for a list of sources and recommended attachments. Any accumulation of lint or debris should be removed at least once a month using your vacuum cleaner. Cleaning the Steam nozzle Once a year, inspect the nozzle outlet. If you suspect blockage, wipe the outside of the nozzle with a cloth moistened with vinegar. If the nozzle is completely blocked, consult the troubleshooting guide (see page 31) for removal and cleaning instructions. If the nozzle remains blocked, call customer service (see page 32). Change the light bulb The dryer light turns on inside the drum when you open the door and stays on for for about 5 minutes or until the door is closed. The light turns off about 4 seconds after the door is closed. To change the light bulb: q Set program selector to Off". q Turn off the circuit breaker. q Unplug the dryer from the power supply. q Open the door and locate the dryer light on the upper left side of the seal. q Loosen the screw and open the dryer light cover. q Turn bulb counterclockwise. Replace the bulb with a new appliance bulb only (obtainable through parts department). i Parts are available at www.boschappliances.com or by calling 1-800-944-2904. q Replace the cover and secure with the screw. q Plug the dryer back into the power supply. q Turn on the circuit breaker. 29