Bosch WTVC5530UC User Guide - Page 31
Troubleshooting continued
View all Bosch WTVC5530UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Troubleshooting (continued) Problem Drum light does not function. Possible cause No program selected. Light bulb defective, light bulb burned out. No power supply. Light bulb is loose. Start/Pause" indicator light does not illuminate. Wrinkle Block/Finished" indicator lights. The display shows 000". Lint filter LED is blinking after the lint filter has been cleaned Display shows ---". Unusual noise: thumping sound Fault in program sequence or malfunction. Blinking of lint filter LED is not an indication of a problem. It is used only as a reminder. Laundry detected in drum during wool program (laundry not on rack) Drum suspension rollers need time to warm up. Unusual noise: Steady vibrationd, rocking of the dryer Unusual noise: Rhythmic vibration Water is not sprayed into the unit during Steam cycles Dryer is not level. Laundry balled up causing load to bounce. Water tap(s) not turned on. Nozzle does not spray water adequately. Blocked nozzle LED or button illuminated on control Fault condition panel when Cycle Selector is turned to Off" position Remedial action Select program. Replace burned out bulb and reinstall the cover as directed on page 29. Check power supply. Remove the bulb cover and if bulb is loose, tighten bulb. Reinstall the cover as directed on page 29. Switch off dryer, leave to cool down for 30 min, switch on again. Restart program. No action required. Light will stop blinking. Place laundry on dryer rack. Restart program. No action required. As suspension system rollers warm up thumping will decrease and should stop within 2 to 3 minutes of dryer use Level the dryer (see user manual section Installation Instructons" Stop dryer, separate load items, restart dryer. Turn on water tap. Wipe the outside of the nozzle with a cloth moistened with vinegar. If this does not restore the nozzle to spraying, see Blocked nozzle" remedial action below. Remove the nozzle using a 7/16 inch (11 mm) socket wrench. Place the nozzle into a container filled with enough white vinegar to cover the nozzle. Allow the nozzle to soak for five minuntes, then scrub the nozzle tip gently with a toothbrush to remove residue. Rinse the nozzle and reinsert it back into the dryer and hand tighten, then tighten 1 additional turn with the wrench. Turn off the circuit breaker and call Customer Service (pg. 32). 31