Brother International DCP 8040 Service Manual - Page 324

MFC-8440/8840D/8840DN, DCP-8040/8045D/8045DN SERVICE MANUAL WSW26 (Function setting 4) Selector No. 1 2 3 4 5 6 7 8 Function Not used. Dialing during document reading into the temporary memory in inmemory message transmission No. of CNG cycles to be detected (when the line is connected via the external telephone except in the external TAD mode) No. of CNG cycles to be detected (when the line is connected via the external telephone in the external TAD mode) Not used. Setting and Specifications 0: Disabled 1: Enabled No. 4 5 0 0 : 0.5 (A) 01 : 1 (B) 1 0 : 1.5 (C) 11 : 2 (D) No. 4 5 0 0 : 0.5 (A) 01 : 1 (B) 1 0 : 1.5 (C) 11 : 2 (D) NOTE: Selectors 6 and 7 take effect only in the V.34 mode. l Selector 3: Dialing during document reading into the temporary memory in in-memory message transmission If this selector is set to "0," the machine waits for document reading into the memory to complete and then starts dialing. This enables the machine to list the total number of pages in the header of the facsimile message. l Selectors 4 and 5: No. of CNG cycles to be detected (when the line is connected via the external telephone except in the external TAD mode) The machine interprets a CNG as an effective signal if it detects a CNG signal by the number of cycles specified by these selectors when the line is connected via the external telephone except in the external TAD mode. l Selectors 6 and 7: No. of CNG cycles to be detected (when the line is connected via the external telephone in the external TAD mode) The machine interprets a CNG as an effective signal if it detects a CNG signal by the number of cycles specified by these selectors when the line is connected via the external telephone in the external TAD mode. A-31