Brother International IntelliFax-3750 Users Manual - English - Page 87

75 R E M O T E F A X O P T I O N S Remote Commands Follow the commands below to access features remotely. When you call the fax machine and enter your Remote Access Code (1 5 9 ), the system will signal you with two short beeps to enter a remote control command. Remote Control Commands Operation Details 95 Changing Fax Forwarding /Paging setting 1 OFF 2 Fax Forwarding 3 Paging 4 FAX FWD No. 6 Fax Storage ON 7 Fax Storage OFF If you hear one long beep, the change is accepted. If you hear three short beeps, you cannot change it because the conditions have not been met (Example: registering paging number). You can register your fax forwarding number by using 4. FAX FWD NO (see page 71). Once you have registered the number, the fax machine will change automatically to FAXFWD:ON mode. Then retrieve a Memory Status List by entering 961 (see page 76) to make sure that the Fax Forwarding number you registered is correct in the List. You can set FAX STORAGE ON or OFF. 96 Retrieve FAX 1 Memory Status List 2 Retrieve all faxes Enter the number of a remote fax machine to receive the Memory Status List or stored fax message(s). (See page 76.) 3 Erase fax from the memory If you hear one long beep, you can erase fax message(s) from the memory. 97 Check the receiving status 1 FAX You can check whether your fax machine has received any fax message(s). If yes, you will hear one long beep. If no, you will hear three short beeps. 98 Change Answer Mode 1 TAD 2 FAX/TEL 3 FAX If you hear one long beep, you can change the Answer Mode. If you hear three short beeps, you cannot change it. 90 Exit After a long beep, you can exit remote control.