Brother International TD-4750TNWB Users Guide - Page 20

Install the Label Roll When Using the Cutter Module (Dealers only), Use the Brother Printer

Get Brother International TD-4750TNWB PDF manuals and user guides View all Brother International TD-4750TNWB manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

3.2.3 Install the Label Roll When Using the Cutter Module (Dealers only) 1. Press the tabs located on each side of the printer, and then lift the Roll Compartment Cover. 2. Install the label roll as described in section 3.2.1 Load Label Roll. 3. Use the Brother Printer Management Tool (BPM) to set the media sensor type and calibrate the selected sensor. 4. Feed the label roll through the media sensor. Adjust the Media Guide Tips to fit the label width. 5. Push the label roll through the Cutter Output Slot. Note Make sure that the label print side is facing up. Media Guide Tips 16

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
16
3.2.3
Install the Label Roll When Using the Cutter Module (Dealers only)
1.
Press the tabs located on each
side of the printer, and then lift the
Roll Compartment Cover.
2.
Install the label roll as described in
section
3.2.1 Load Label Roll
.
3. Use the Brother Printer
Management Tool (BPM) to set the
media sensor type and calibrate
the selected sensor.
4.
Feed the label roll through the
media sensor. Adjust the Media
Guide Tips to fit the label width.
5.
Push the label roll through the
Cutter Output Slot.
Note
Make sure that the label print side
is facing up.
Media Guide Tips