Brother International TD-4750TNWB Users Guide - Page 32

Self-test, For the Black Mark Sensor: send the BLINE command

Get Brother International TD-4750TNWB PDF manuals and user guides View all Brother International TD-4750TNWB manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

4. The printer calibrates the sensor and detects the label length, prints the internal settings, and then enters Dump Mode. Note To select the sensor for calibration, send the correct command to the printer:  For the Gap Sensor: send the GAP command  For the Black Mark Sensor: send the BLINE command For more information about the available commands, see the FBPL Command Reference Manual on your model's Manuals page at support.brother.com.  Self-test Print the printer configuration after you run Gap/Black Mark Sensor calibration. The self-test printout lists the printer's configuration and available memory, and can indicate if there is any dot damage on the heater component. Self-test printout Model name Firmware version Firmware checksum Printer serial number Configuration file System date System time Printed mileage (meter) Cutting counter Number of defective dots Print speed (inch/sec) Print density Label size (inch) Gap distance (inch) Gap/Black Mark Sensor sensitivity Code page Country code 28

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
28
4. The printer calibrates the sensor and detects the label length, prints the internal settings,
and then enters Dump Mode.
Note
To select the sensor for calibration, send the correct command to the printer:
For the Gap Sensor: send the GAP command
For the Black Mark Sensor: send the BLINE command
For more information about the available commands, see the
FBPL Command Reference
Manual
on your model's
Manuals
page at
support.brother.com
.
Self-test
Print the printer configuration after you run Gap/Black Mark Sensor calibration. The self-test
printout lists the printer's configuration and available memory, and can indicate if there is any
dot damage on the heater component.
Self-test printout
Model name
Firmware version
Firmware checksum
Printer serial number
Configuration file
System date
System time
Printed mileage (meter)
Cutting counter
Number of defective dots
Print speed (inch/sec)
Print density
Label size (inch)
Gap distance (inch)
Gap/Black Mark Sensor
sensitivity
Code page
Country code