Cisco 7600 SIP 200 Hardware Installation Guide - Page 152
Checking the Installation
UPC - 746320961286
View all Cisco 7600 SIP 200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
Checking the Installation Chapter 6 Installing and Removing a Shared Port Adapter Checking the Installation This section describes the procedures you can use to verify the SIP and SPA installation, and includes information on the following topics: • Verifying the Installation, page 6-4 • Using show Commands to Verify SIP and SPA Status, page 6-5 • Using show Commands to Display SPA Information, page 6-6 Verifying the Installation This section describes how to verify the SIP and SPA installation by observing the SIP LED states, SPA LED states, and the information displayed on the console terminal. When the system has reinitialized all interfaces, the SIP STATUS LED should be green (on) and the SPA STATUS LEDs should be green (on). The port LEDs (C/A and A/L) may be green (on), depending on your connections and configuration. The console screen also displays a message as the system discovers each interface during its reinitialization. Note A POS interface is used in the following examples for illustrative purposes. The following sample display shows the events logged by the system as a SIP with a POS SPA was removed from module slot 4 in the router. In this example, interface 0 (interface 4/0/0) on the POS SPA was up and active when the SIP was removed from the router. Note that the system logs that the SIP card was removed from slot 4 and that interface 4/0/0 is changed to down. Router# 00:06:17:%WS_ALARM-6-INFO:ASSERT CRITICAL slot 4 Active Card Removed OIR Alarm 00:06:17:%OIR-6-REMCARD:Card removed from slot 4, interfaces disabled 00:06:18:%LINEPROTO-5-UPDOWN:Line protocol on Interface pos4/0/0, changed state to down When you reinsert the SIP with the installed POS SPA, the system automatically brings up the interface that was changed to down when the SIP was removed. Router# 00:07:29:%OIR-6-INSCARD:Card inserted in slot 4, interfaces administratively shut down 00:07:32:%WS_ALARM-6-INFO:CLEAR CRITICAL slot 4 Active Card Removed OIR Alarm 00:07:35:%LINK-3-UPDOWN:Interface pos4/0/0, changed state to up 00:07:36:%LINEPROTO-5-UPDOWN:Line protocol on Interface pos4/0/0, changed state to up Use the following procedure to verify that a SIP and SPA are installed correctly: Step 1 Observe the console display messages and verify that the system discovers the SIP, while the system reinitializes each interface, as follows: • As a SIP is initialized, the STATUS LED will first be amber, indicating that power is on, but the SIP is being configured. When the SIP is active, the STATUS LED will illuminate green. • SPAs will follow the same sequence once the SIP has completed its initialization. The SPA STATUS LEDs will illuminate amber, turning to green when the SPAs become active. • When the SIP and SPA STATUS LEDs are green, all associated interfaces are configurable. Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide 6-4 OL-5052-14