Cisco 7600 SIP 200 Hardware Installation Guide - Page 93
-Port OC-192c/STM-64 POS/RPR VSR Optics SPA Interface Specifications
UPC - 746320961286
View all Cisco 7600 SIP 200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Chapter 3 Overview: Cisco 7600 Series Router Shared Port Adapters 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA Overview Table 3-22 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA LEDs (continued) LED Label PASSTHRU MATESYNC CARRIER Color Off Amber Off Green Off Green Amber ACTIVE STATUS Off Green Amber Off Green Amber State Meaning Off Port is not in pass-through mode. On Port is in pass-through mode. Off Mate port is not synchronized. On Mate port is synchronized. Off Port is not enabled by software. On Port is enabled by software, and there is a valid SONET signal without alarms. On Port is enabled by software, and there is at least one alarm (LOS, LOF, RDI, and so on). Blinking SRP mode mismatch alarm is indicated. Off Port is not enabled by software. On Port is enabled by software, and loopback is off. On Port is enabled by software, and loopback is on. Off SPA power off. On SPA is ready and operational. On SPA power is on and good, and the SPA is being configured. 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA Interface Specifications The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA contains a SONET/SDH framer to process incoming and outgoing SONET or SDH frames. The framer operates at OC-192/STM-64 line rates (9.95 Gbps). Packet data is transported with a user-configured encapsulation (such as Point-to-Point Protocol [PPP]) and is mapped into the STS-192c/STM-64 frame. The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA interface is compliant with the following RFCs: • RFC 1662, PPP in HDLC-like Framing • RFC 2615, PPP over SONET/SDH For information on SNMP MIB support, see "Implementing SNMP on Cisco IOS XR Software" in Cisco IOS XR System Management Configuration Guide. 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA Fixed Optical Transceiver, Connector, and Cables The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA uses fixed optical transceivers, one for receive (RX) and one for transmit (TX), for SONET and SDH connection to the network. Only Very Short Reach (VSR) optics are supported. The 1-Port OC-192c/STM-64 POS/RPR VSR Optics SPA uses multimode MTP-type connectors: • Multimode-9.95 Gbps, OC-192 optical fiber (SONET STS-192c or SDH STM-64c) OL-5052-14 Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide 3-47