Craftsman 536.270320 Operation Manual - Page 20
How To Operate With The Mower Housing, Hills - replacement parts
View all Craftsman 536.270320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
OPERATION HOW TO OPERATE WITH THE MOWER HOUSING WARNING: The mulch cover is a safety device. Do not remove the mulch cover. The side discharge attach- _b mgreonutndf.orAclewsaysthekeedpiscthheargseidde dmisacthearriagle taotwtaacrhdmetnhte in the down position. If the side discharge attachment is damaged, replace the with an original equipment part from a Sears Service Center. IMPORTANT: When you operate with the mower housing, always operate with the throttle control in the FAST position. 1. Push the clutch/brake pedal completely forward. 2. Start the engine. 3. Put the speed control lever in the NEUTRAL position. 4. Slowly release the clutch/brake pedal. 5. Move the lift lever to a height of cut position. In high or thick grass, cut the grass in the highest position first and then lower the mower housing to a lower position. CAUTION: Do not operate with the mower housing in the LEVEL ADJUSTMENT position. If you operate in the LEVEL ADJUSTMENT position, the mower housing and blades can be damaged. 6. Move the throttle control to the SLOW position. 7. Move the attachment clutch to the ENGAGE position. 8. Move the speed control lever forward. NOTE: When you mow in heavy grass or mow with a bagger, operate at a slow forward speed. Move the throttle control to the FAST position. If you need to go faster or slower, move the speed control lever forward or backward. 10. Make sure the level of cut is still correct. After you mow a short distance, look at the area that was cut. If the mower housing does not cut level, see the instructions on "How To Level The Mower Housing" in the Service And Adjustment section. _b seAleRcNt INa Gs:afe sFpoeredb.etter control of the unit, always HOW TO OPERATE THE UNIT ON HILLS steep to back straight up. Never ride the unit across _ Wa AsRloNpIeN.GS: eeDothneot"Srildoepeup Gour iddoe"wninslothpeesbathcakt aorfe tthoios book for information on how to check slopes. 1. Before you ride up or down a hill, move the speed control lever to a slow speed. 2. Do not stop or change speed settings on a hill. If you must stop, quickly push the clutch/brake pedal forward and set the parking brake. 3. To start again, make sure the speed controUever is in a slow speed. Move the throttle control to the SLOW position. Slowly release the pedal. 4. If you must stop or start on a hill, always have enough space for the unit to roll when you release the brake and engage the clutch. 5. Be very careful when you change directions on a hill. When on a slope or in a turn on a hill, move the throttle control to the SLOW position to help prevent an accident. MS-3620MA 20