Cub Cadet CC30H Riding Lawn Mower Operation Manual - Page 20

PRODUCT CARE MAINTENANCE SCHEDULE WARNING Before performing any type of maintenance/service, disengage all controls and stop the engine. Wait until all moving parts have come to a complete stop. Allow the engine to cool. Disconnect spark plug wire(s) and negative battery cable to prevent unintended starting. Always wear safety glasses during operation or while performing any adjustments or repairs. Follow the maintenance schedule given below. This chart describes service guidelines only. Before Every Every Every Every Prior to Each Use 10 Hours 25 Hours 50 Hours 100 Hours Storing Check/Clean Engine Intake Screens & Cooling Fans * P P Check/Clean Exhaust Manifold, Muffler Pipe & Muffler Shields * P P Check/Clean Hood/Dash Panel Louvers * P P Check/Clean Top & Underside of Deck, Under & Around Spindle Covers & Belt Area * P P Check/Clean Around Fuses, Wiring & Wiring Harnesses * P P Check/Clean Around Transmission, Axle & Fans * P P Check Engine Oil Level PP Check Air Filter for Dirty, Loose or Damaged Parts P Clean & Re-oil Air Filter's Foam Pre-cleaner (If equipped) P Replace Air Filter Element P Change Engine Oil & Replace Oil Filter (If equipped) P Lube Front Axles & Rims P P Check Spark Plug Condition & Gap PP Replace Fuel Filter P * -- Perform more often in dry conditions and/or when mulching. IMPORTANT! It is important to consult the specific Engine Operator's Manual included with this machine for detailed engine maintenance procedures and intervals. NOTE: This Operator's Manual covers several models. Riding mower features may vary by model. Not all features in this manual are applicable to all riding mower models and the riding mower depicted may differ from yours. POST-OPERATION RIDER CARE After each operation of the rider, the following procedures should be implemented to extend the life of your rider and ensure safe operating conditions. WARNING Failure to follow these recommendations may result in serious injury to yourself or others and may cause damage to the rider. Cleaning the Underside of the Deck DECK WASH SYSTEM (IF EQUIPPED) Your rider's deck may be equipped with a water port on its surface as part of its deck wash system. Use the deck wash system to rinse grass clippings from the deck's underside and prevent the build-up of corrosive chemicals. Complete the following steps AFTER EACH MOWING: 1. Drive the rider to a level, clear spot on your lawn, near enough for your garden hose to reach. 20