Dell Dimension 2010 Service Manual - Page 40

Connect your computer and devices to their electrical outlets, and turn

Get Dell Dimension 2010 PDF manuals and user guides View all Dell Dimension 2010 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 40 highlights

5 Gently slide the optical drive into place. 6 Align the screw holes in the optical drive with the screw holes in the optical drive bay. 7 Replace the four screws that secure the optical drive to the optical drive bay. 8 Connect the power and data cables to the optical drive. 9 Ensure that you connect the data cable to the system board connector, if you disconnected it while removing the optical drive. For the location of the SATA connectors, see "System Board Components" on page 8. 10 Replace the front bezel (see "Replacing the Front Bezel" on page 20). 11 Replace the computer cover on both the sides (see "Replacing the Computer Cover" on page 16). 12 Connect your computer and devices to their electrical outlets, and turn them on. See the documentation that came with the optical drive for instructions on installing any software required for drive operation. 13 Check the System Setup for drive configuration changes (see "Entering System Setup" on page 69). 40 Drives

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
40
Drives
5
Gently slide the optical drive into place.
6
Align the screw holes in the optical drive with the screw holes in the optical
drive bay.
7
Replace the four screws that secure the optical drive to the optical drive
bay.
8
Connect the power and data cables to the optical drive.
9
Ensure that you connect the data cable to the system board connector, if
you disconnected it while removing the optical drive. For the location of
the SATA connectors, see "System Board Components" on page 8.
10
Replace the front bezel (see "Replacing the Front Bezel" on page 20).
11
Replace the computer cover on both the sides (see "Replacing the
Computer Cover" on page 16).
12
Connect your computer and devices to their electrical outlets, and turn
them on.
See the documentation that came with the optical drive for instructions
on installing any software required for drive operation.
13
Check the System Setup for drive configuration changes (see "Entering
System Setup" on page 69).