Dell Dimension 2010 Service Manual - Page 45
Replacing the Power Switch Module
View all Dell Dimension 2010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
8 Slide the holder along with the hard drive activity light and cable out through the front of the computer. Replacing the Power Switch Module 1 Slide the power switch module through the slot on the front panel. 2 Press the holder and gently snap it into the front panel until it clicks into place. 3 Gently push the hard drive activity light into its holder. 4 Connect the power switch module cable to the power switch module connector (FP1) on the system board. 5 Replace the hard drive (see "Replacing a Hard Drive" on page 33). 6 Replace the front bezel (see "Replacing the Front Bezel" on page 20). 7 Replace the computer cover on both the sides (see "Replacing the Computer Cover" on page 16). Power Switch Module 45
Power Switch Module
45
8
Slide the holder along with the hard drive activity light and cable out
through the front of the computer.
Replacing the Power Switch Module
1
Slide the power switch module through the slot on the front panel.
2
Press the holder and gently snap it into the front panel until it clicks into
place.
3
Gently push the hard drive activity light into its holder.
4
Connect the power switch module cable to the power switch module
connector (FP1) on the system board.
5
Replace the hard drive (see "Replacing a Hard Drive" on page 33).
6
Replace the front bezel (see "Replacing the Front Bezel" on page 20).
7
Replace the computer cover on both the sides (see "Replacing the
Computer Cover" on page 16).