Dell Equallogic PS4110X PS4110 Hardware Owners Manual - Page 10

One STOP bit, Log in to an account with read-write access, such as

Get Dell Equallogic PS4110X PDF manuals and user guides View all Dell Equallogic PS4110X manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

Hardware Owner's Manual 1 Basic Storage Array Information • Use telnet or SSH to connect to a functioning IP address assigned to a network interface on the array. Do not connect to the group IP address. • Use the null modem cable shipped with the array to connect to the serial port on the active control module (ACT LED is green) to a console or a computer running a terminal emulator. Make sure the serial line characteristics are as follows: • 9600 baud • One STOP bit • No parity • 8 data bits • No flow control 2. Log in to an account with read-write access, such as the grpadmin account. 3. Enter the shutdown command, as shown next. login: grpadmin Password: Welcome to Group Manager Copyright 2001-2011 Dell, Inc. group1> shutdown If you are using a serial connection to shut down an array, it is safe to turn off power when the "press any key" message appears. (Pressing any key will restart both control modules.) If you are using a network connection, the session will be disconnected before the array is fully shut down. Confirm that the ACT LED on each control module is off (not lit) before turning off power to the array. After performing array maintenance, you can turn on power to the array. When the array restart completes, the member and volumes will be set online. 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
Hardware Owner's Manual
1 Basic Storage Array Information
•
Use telnet or SSH to connect to a functioning IP address assigned to a network interface on the array.
Do not connect to the group IP address.
•
Use the null modem cable shipped with the array to connect to the serial port on the active control mod-
ule (ACT LED is green) to a console or a computer running a terminal emulator.
Make sure the serial line characteristics are as follows:
•
9600 baud
•
One STOP bit
•
No parity
•
8 data bits
•
No flow control
2.
Log in to an account with read-write access, such as the
grpadmin
account.
3. Enter the
shutdown
command, as shown next.
login:
grpadmin
Password:
Welcome to Group Manager
Copyright 2001-2011 Dell, Inc.
group1>
shutdown
If you are using a serial connection to shut down an array, it is safe to turn off power when the “press any key”
message appears. (Pressing any key will restart both control modules.)
If you are using a network connection, the session will be disconnected before the array is fully shut down.
Confirm that the ACT LED on each control module is off (not lit) before turning off power to the array.
After performing array maintenance, you can turn on power to the array. When the array restart completes, the
member and volumes will be set online.
6