Dell Latitude 7350 Detachable Owners Manual - Page 78
Installing the heat sink (non-Vapor Chamber), Removing the heat sink non-Vapor Chamber
View all Dell Latitude 7350 Detachable manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Figure 46. Removing the heat sink (non-Vapor Chamber) Steps 1. Peel back the WLAN and the WWAN antenna grounding foil (for computers with WWAN support) from the heat sink. 2. Using a plastic scribe, pry the heat sink shield from the opening at the top-right side. 3. Remove the shielding from the computer. 4. Loosen the three captive screws (M1.6x2.3) that secure the heat sink into place in this sequence: 3 > 2 > 1. 5. Gently lift and remove the heat sink from the computer. Installing the heat sink (non-Vapor Chamber) CAUTION: The information in this installation section is intended for authorized service technicians only. Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following images indicate the location of the heat sink and provides a visual representation of the installation procedure. 78 Removing and installing Field Replaceable Units (FRUs)