Dell Latitude 7350 Detachable Owners Manual - Page 92
Installing the world-facing camera, Removing the world-facing camera
View all Dell Latitude 7350 Detachable manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
Figure 57. Removing the world-facing camera Steps 1. Remove the two screws (M1.6x3) that secure the world-facing camera in place. 2. Disconnect the world-facing camera FPC from the connector (CAM) on the system board. 3. Lift the world-facing camera out of the computer. 4. Lift the front-facing camera bracket out of the computer. NOTE: Remove the front-facing camera bracket immediately after removing the world-facing camera to prevent the bracket from falling out of the computer during replacement procedures. Installing the world-facing camera CAUTION: The information in this installation section is intended for authorized service technicians only. Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following images indicate the location of the world-facing camera and provides a visual representation of the installation procedure. 92 Removing and installing Field Replaceable Units (FRUs)