Dell PowerEdge 1955 Configuration Guide - Page 13
Configuring the DRAC/MC Module, DRAC/MC Module Features - power guide
View all Dell PowerEdge 1955 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Configuring the DRAC/MC Module This section includes general configuration information for the DRAC/MC module. For detailed information on configuring the DRAC/MC and using the remote management features of the DRAC/MC, see the Dell Remote Access Controller/Modular Chassis User's Guide. DRAC/MC Module Features The DRAC/MC provides serial and Ethernet management ports, a status indicator when redundant DRAC/MCs are installed, and status indicators for the DRAC/MC (see Figure 1-4). Table 1-1 provides information about the status indicators. NOTICE: The DRAC/MC must have a firmware version of 1.3 or later. NOTICE: To support redundant DRAC/MC operation, both modules must have firmware version 1.3 or later. Mixing two DRAC/MC modules with firmware versions earlier than 1.3 may cause the enclosure to power down I/O modules in bays I/O 3 and I/O 4 without user intervention. See "Updating the DRAC/MC Module Firmware" on page 19 for information on updating the firmware. Figure 1-4. DRAC/MC Module Features 1 2 3 5 4 M S 1 activity indicator 4 fault indicator 2 link indicator 5 serial connector 3 primary/standby indicator (redundant DRAC/MC configurations only) General System Configuration 11