Dell PowerEdge 1955 Configuration Guide - Page 29
Updating the PowerConnect Switch Module Firmware, PowerConnect, 5316M User's Guide - ram
View all Dell PowerEdge 1955 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
NOTE: The SNMP community string established in this example allows all host stations to access the switch via SNMP. To limit SNMP access to a single management station, add the specific IP address to the end of the command. 7 Configure the SNMP read/write access and community string "private" with the following command: console(config)# snmp-server community private rw 8 Ensure that the IP address and the default gateway were properly assigned by executing the following command and examining its output: console(config)# exit console# show ip interface vlan 1 9 Once you have confirmed the configuration settings, save the running configuration to the startup configuration: console# copy running-config startup-config The startup configuration is stored in the non-volatile memory of the switch module and is loaded into the running configuration (which is kept in the RAM) each time the module boots. For additional information and details on configuration procedures, see the Dell PowerConnect 5316M User's Guide. Updating the PowerConnect Switch Module Firmware This section contains instructions for downloading a new PowerConnect 5316M Ethernet switch module software system image through a TFTP server. The TFTP server must be configured before you begin to download the software. NOTE: You can download a TFTP server from http://solarwinds.net. For information on installing and configuring the SolarWinds TFTP server, refer to the SolarWinds website. System Image Download The Ethernet switch module boots and runs when decompressing the system image from the flash memory area where a copy of the system image is stored. When a new image is downloaded, it is saved in the area allocated for the other system image copy. On the next boot, the Ethernet switch module will decompress and run the currently active system image unless chosen otherwise. General System Configuration 27