Dell PowerEdge C6520 EMC Installation and Service Manual - Page 38

Removing the expansion card riser 2

Get Dell PowerEdge C6520 PDF manuals and user guides View all Dell PowerEdge C6520 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 38 highlights

3. Using a Phillips #1 screwdriver, tighten the screws that secure the expansion card riser 1 on to the system board. Figure 39. Installing the expansion card riser 1 Next steps Follow the procedure listed in After working inside your system. Removing the expansion card riser 2 Prerequisites NOTE: Install an expansion card filler bracket over an empty expansion slot to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system. 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure listed in Before working inside your system. 3. Remove the expansion card riser 1. Steps 1. Using Phillips #1 screwdriver, remove the screws that secure the expansion card riser 2. 2. Holding the blue touch point and handle, lift the expansion card riser from the riser connector on the system board. 38 Installing and removing system components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
3.
Using a Phillips #1 screwdriver, tighten the screws that secure the expansion card riser 1 on to the system board.
Figure 39. Installing the expansion card riser 1
Next steps
Follow the procedure listed in
After working inside your system
.
Removing the expansion card riser 2
Prerequisites
NOTE:
Install an expansion card filler bracket over an empty expansion slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper
cooling and airflow inside the system.
1.
Follow the safety guidelines listed in
Safety instructions
.
2.
Follow the procedure listed in
Before working inside your system
.
3.
Remove the expansion card riser 1
.
Steps
1.
Using Phillips #1 screwdriver, remove the screws that secure the expansion card riser 2.
2.
Holding the blue touch point and handle, lift the expansion card riser from the riser connector on the system board.
38
Installing and removing system components