Dell PowerEdge C6520 EMC Installation and Service Manual - Page 58
Removing a memory module, Table 15. Memory population rules
![]() |
View all Dell PowerEdge C6520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Table 15. Memory population rules Processor Configuration Memory population Memory population information Single processor Optimizer (Independent A{1}, A{2}, A{3}, A{4}, A{5}, A{6}, 1, 2, 3, 4 DIMMs are channel) population order A{7}, A{8} allowed. Dual processor (Start with processor1. Processor 1 and processor 2 population should match) Optimizer (Independent channel) population order A{1}, B{1}, A{2}, B{2}, A{3}, B{3}, 1, 2, 3, 4, 5, 6, 7, 8 DIMMs A{4}, B{4}, A{5}, B{5}, A{6}, B{6}, are supported per system . A{7}, B{7} A{8}, B{8} NOTE: Optimizer population order is not traditional for 8 and 16 DIMMs installations for dual processor. ● Memory modules of different capacities can be mixed provided other memory population rules are followed. NOTE: For example, 8 GB and 16 GB memory modules can be mixed. ● Mixing of more than two memory module capacities in a system is not supported. ● Unbalanced or odd memory configuration results in a performance loss and system may not identify the memory modules being installed, so always populate memory channels identically with equal DIMMs for best performance. ● Supported RDIMM / LRDIMM configurations are 1, 2, 3, 4 DIMMs per processor. ● Populate eight equal memory modules per processor (one DIMM per channel) at a time to maximize performance. NOTE: Equal memory modules refer to DIMMs with identical electrical specification and capacity that may be from different vendors. Removing a memory module Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. Remove the air shroud. WARNING: The memory modules are hot to touch for some time after the system has been powered off. Allow the memory modules to cool before handling them. NOTE: To ensure proper system cooling, memory module blanks must be installed in any memory socket that is not occupied. Remove memory module blanks only if you intend to install memory modules in those sockets. Steps 1. Locate the appropriate memory module socket. 2. To release the memory module from the socket, simultaneously press the ejectors on both ends of the memory module socket to fully open. CAUTION: Handle each memory module only by the card edges, ensuring not to touch the middle of the memory module or metallic contacts. 3. Lift the memory module away from the system. 58 Installing and removing system components
![](/manual_guide/products/dell-poweredge-c6520-emc-installation-service-manual-952243c/58.png)