Dell PowerEdge C6520 EMC Installation and Service Manual - Page 63

Aligning pin 1 marks of processor with tray, Removing the processor retaining

Get Dell PowerEdge C6520 PDF manuals and user guides View all Dell PowerEdge C6520 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 63 highlights

Figure 68. Aligning pin 1 marks of processor with tray NOTE: Ensure that to return the TIM break lever back to its original position. 4. Using your thumb and index finger, first hold the retaining clip release tab at the pin 1 connector, pull out the tip of the retaining clip release tab, and then lift the retaining clip partially from the heat sink. 5. Repeat the procedure at the remaining three corners of the retaining clip. 6. After all the corners are released from the heat sink, lift the retaining clip from the pin 1 corner of the heat sink. Figure 69. Removing the processor retaining clip Next steps Replace the processor into a processor and heat sink module (PHM). Installing and removing system components 63

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
Figure 68. Aligning pin 1 marks of processor with tray
NOTE:
Ensure that to return the TIM break lever back to its original position.
4.
Using your thumb and index finger, first hold the retaining clip release tab at the pin 1 connector, pull out the tip of the
retaining clip release tab, and then lift the retaining clip partially from the heat sink.
5.
Repeat the procedure at the remaining three corners of the retaining clip.
6.
After all the corners are released from the heat sink, lift the retaining clip from the pin 1 corner of the heat sink.
Figure 69. Removing the processor retaining clip
Next steps
Replace the processor into a processor and heat sink module (PHM)
.
Installing and removing system components
63