Dell PowerEdge C6520 EMC Installation and Service Manual - Page 55
Installing the linking board and PCIe cable
View all Dell PowerEdge C6520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Figure 60. Removing the linking board and PCIe cable 4. To disengage the linking board connector, lift and push the MB cable towards the front of the sled. 5. Remove the MB cable from the sled. Next steps Replace the linking board and PCIe cable. Installing the linking board and PCIe cable Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure listed in Before working inside your system. Steps 1. Route the MB cable along the chassis wall. 2. Align the linking board connector with the screw holes on the chassis and using a Phillips #2 screwdriver tighten the captive screws to secure the linking board cable connector to the chassis. 3. Connect the MB connectors to the connectors on the system board. Installing and removing system components 55