Dell PowerEdge C6520 EMC Installation and Service Manual - Page 43

Installing an expansion card, Installing the expansion card filler bracket in riser 2

Get Dell PowerEdge C6520 PDF manuals and user guides View all Dell PowerEdge C6520 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 43 highlights

Figure 45. Installing the expansion card filler bracket in riser 2 Next steps Replace the expansion card. Installing an expansion card Prerequisites CAUTION: Expansion cards can only be installed in the slots on the expansion card riser. Do not attempt to install expansion cards directly into the riser connector on the system board. 1. Follow the safety guidelines listed in Safety Instructions. 2. Unpack the expansion card and prepare it for installation. For instructions, see the documentation accompanying the card. Steps 1. If installed, remove the filler bracket by performing the following steps: a. Remove the screw that secures the filler bracket. b. Hold the filler bracket by its edges, and remove it from the riser. NOTE: You must install an expansion card filler bracket over an empty expansion slot to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system. Installing and removing system components 43

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
Figure 45. Installing the expansion card filler bracket in riser 2
Next steps
Replace the expansion card
.
Installing an expansion card
Prerequisites
CAUTION:
Expansion cards can only be installed in the slots on the expansion card riser. Do not attempt to
install expansion cards directly into the riser connector on the system board.
1.
Follow the safety guidelines listed in
Safety Instructions
.
2.
Unpack the expansion card and prepare it for installation. For instructions, see the documentation accompanying the card.
Steps
1.
If installed, remove the filler bracket by performing the following steps:
a.
Remove the screw that secures the filler bracket.
b.
Hold the filler bracket by its edges, and remove it from the riser.
NOTE:
You must install an expansion card filler bracket over an empty expansion slot to maintain Federal
Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the
system and aid in proper cooling and airflow inside the system.
Installing and removing system components
43