Dell PowerEdge C6520 EMC Installation and Service Manual - Page 39
Installing the expansion card riser 2
View all Dell PowerEdge C6520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Figure 40. Removing the expansion card riser 2 Next steps Replace the expansion card riser 2. Installing the expansion card riser 2 Prerequisites NOTE: You must install an expansion card filler bracket over an empty expansion slot to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system. 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure listed in Before working inside your system. Steps 1. Align the screw holes on the riser with the screw holes on the chassis. 2. Lower the riser firmly until the riser card is fully seated in the slot. 3. Using a Phillips #1 screwdriver, tighten the screws that secure the expansion card riser 2 on to the system board. Installing and removing system components 39