Dell PowerEdge T140 EMC Installation and Service Manual - Page 60

Storage controller card, Removing the integrated storage controller card

Get Dell PowerEdge T140 PDF manuals and user guides View all Dell PowerEdge T140 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 60 highlights

Figure 31. Installing a PCIe expansion card Next steps 1. Connect the cables to the expansion card. 2. Install any device drivers required for the card as described in the documentation for the card. 3. Follow the procedure that is listed in After working inside your system. Storage controller card Removing the integrated storage controller card Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure that is listed in Before working inside your system. 3. Press the release tab on the SAS cable connector to disconnect the cable from the storage controller card. Steps 1. Press the expansion card retention latch and push down the latch to open it. 2. Hold the expansion card by the edge, and pull the card to disconnect from the system board connector. 60 PowerEdge T140 installing and removing system components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
Figure 31. Installing a PCIe expansion card
Next steps
1.
Connect the cables to the expansion card.
2.
Install any device drivers required for the card as described in the documentation for the card.
3.
Follow the procedure that is listed in
After working inside your system
.
Storage controller card
Removing the integrated storage controller card
Prerequisites
1.
Follow the safety guidelines listed in
Safety instructions
.
2.
Follow the procedure that is listed in
Before working inside your system
.
3.
Press the release tab on the SAS cable connector to disconnect the cable from the storage controller card.
Steps
1.
Press the expansion card retention latch and push down the latch to open it.
2.
Hold the expansion card by the edge, and pull the card to disconnect from the system board connector.
60
PowerEdge T140 installing and removing system components