Dell PowerEdge T140 EMC Installation and Service Manual - Page 81
Initializing the TPM 2.0 for TXT users, Control panel, Removing the control panel cage
View all Dell PowerEdge T140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Initializing the TPM 2.0 for TXT users Steps 1. While booting your system, press F2 to enter System Setup. 2. On the System Setup Main Menu screen, click System BIOS > System Security Settings. 3. From the TPM Security option, select On. 4. Save the settings. 5. Restart your system. 6. Enter System Setup again. 7. On the System Setup Main Menu screen, click System BIOS > System Security Settings. 8. Select the TPM Advanced Settings option. 9. From the TPM2 Algorithm Selection option, select SHA256, then go back to System Security Settings screen. 10. On the System Security Settings screen, from the Intel TXT option, select On. 11. Save the settings. 12. Restart your system. Control panel Removing the control panel cage Prerequisites 1. Follow the safety guidelines listed in Safety instructions 2. Follow the procedure that is listed in Before working inside your system. 3. Disconnect all peripherals that are connected to the control panel. 4. Disconnect the control panel cable and control panel USB cable from the system board. CAUTION: Do not use excessive force when removing the control panel cables as it can damage the connectors. 5. Remove the front bezel. Steps 1. Using the Phillips #1 screwdriver, remove the screws that secure the control panel cage to the system. 2. Slide the control panel cage out of the system along with the cables. Figure 54. Removing the control panel cage PowerEdge T140 installing and removing system components 81