Epson ActionTower 3000 User Manual - Page 49
Changing the Jumper Settings, tables are the only ones you may need to change; others are
![]() |
View all Epson ActionTower 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Changing the Jumper Settings The jumpers on the main system board control certain functions and are preset at the factory to default positions; however, you can use the information in the following tables to change their settings, if necessary. (The jumpers listed in the tables are the only ones you may need to change; others are for service purposes only.) Miscellaneous jumper settings jumper number JA Jumper setting 1-2* 2-3 Function Enables LPT (parallel port) Disables LPT (parallel port) JB** 21--32* Enables HDC (lDE hard disk drive controler) Disables HDC ODE hard disk drive controler) JC 21--32* Enables COMA (serial port1) Disables COMA (serial part 1) JD 1-2* 2-3 Enables COMB (serial port 2) Disables COMB (serial-port 2) JE** 1-2* 2-3 Enables HDC (lDE hard disk drive controller) Dlsablss HDC (IDE hard disk drive controller) J4 1-2 Enables game port (J1) 2-3* Disables game port (J1) J5 J6 J7 J8 J10 J17*** 1-2* 2-3 1-2* 2-3 12--32 * 1-2* 2-3 On* Off 1-2 3-4 1-2, 3-4 5-6 Assigns the parallel port as LPTl (378h-37Fh) Assigns the parallel port as LPT2 (278h-27Fh) Assigns serial port 1 as COM1 (3F8h-3FFh) Assigns serial port 1 as COM3 (3E8h-3EFh) AAssssigignnssseseriarllapl oprot r2t a2saCs OCMOM2 4(2(F28Eh8h-2-2FEFFhh)) Enables the diskette drive controlIer Disables the diskette drive controller Enables VGA interrupt Disables VGA interrupt Microprocessor installed runs at 33 MM or 66 MM or a multiple of these (486SX/33. 486DX/33, 486DX2/66, DX4/100 and Pentium) Microprocessor installed is a 486DX/50 Microprocssor installed is a DX/40 Microprocessor installed at 25 MHz or 50 MHz or a multIpIe of these (486SX/25, 486DX2/50. DX4/75. and SX2/50) 3-6 Installing and Removing Options
![](/manual_guide/products/epson-actiontower-3000-user-manual-68dffb2/49.png)