Epson ActionTower 3000 User Manual - Page 71
CHAP 4-INSTALLING AND REMOVING DRIVES, described in the table below.
![]() |
View all Epson ActionTower 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Chapter 4 Installing and Removing Drives This chapter describes how to install and remove optional drives in your computer. You can use these instructions to install a variety of devices, including hard disk, diskette, tape, CD-ROM, and optical drives. Although your drive may look different from the ones illustrated here, you should be able to install it the same way. Your computer can hold up to seven mass storage devices, as described in the table below. Drive bay Four externally accessible bays One front internal bay Two rear internal bays Drive type and size Two 5,25-inch, half-height drives or one 525-inch. full-height drive and two 3 S-inch, half-height drives One 3,5-inch. half-height or third-height drive Two 3.5-inch, half-height or third-height, or one 3.5-inch, full-height drive Note The main system board in your computer supports up to two diskette drives (or one diskette drive and one tape drive) and up to two IDE hard disk drives. If you install more than four drives, you must install a drive controller on an option card, such as a SCSI controller card, for the additional drive(s). Installing and Removing Drives 4-1
![](/manual_guide/products/epson-actiontower-3000-user-manual-68dffb2/71.png)