Epson FX 1170 Service Manual - Page 86
Removing the FRAME ASSEMBLY, REAR
View all Epson FX 1170 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
3.2.5.2 Removing the FRAME ASSEMBLY, REAR REV.-A [STEP 11 [STEP 2] [STEP 31 [STEP 41 [STEp 51 [STEp 61 [STEp 71 [STEp 81 [STEp 91 Remove the PAPER GUIDE ASSEMBLY, top cover, front cover, paper eject cover and tractor unit. (See Section 3.2.1.) Remove the PANEL UNIT. (See Section 3.2.2.) Remove the HOUSING ASSEMBLY, UPPER. (See Section 3.2.4.) Remove the PRINTER MECHANISM. (See Section 3.2.5.) Remove the PLATEN ASSEMBLY. (See Section 3.2.5.1.) Remove the four CBS (M3X8) screvvs securing the LEFT FRAME of the pRINTER MECHANISM~ and the nut and washer securing the LEVER, G, ADJUST. Remove the BUSHING, PARALLEL, ADJUST. Remove the LEFT FRAME. Remove the FFC cables from the RIGHT FRAME of the PRINTER MECHANISM, and then the two CBS (M3X8) screws securing the RIGHT FRAME. Remove the FRAME ASSEMBLY, REAR. Push the clip on the back of the FRAME ASSEMBLY, REAR. Slide out the FRAME, REAR. Hexagon Outside Lock W BUS = L E FT F R A M E . CBS (M3X8) < P A P E R G U I D E A S S E M B L Y , R E A R ~ I /\\ Y> Figure 3-9. Removing the FRAME ASSEMBLY, REAR 3-11